Double A Willow

Fedge Planting Instructions

Fedge
10 willow rods per 3 feet + 1 extra for each end.

You Will Need:

  1. 42 willow rods (for 12 feet of fedge)
  2. Weed mat and securing pins
  3. Tape measure
  4. Ties to secure fedge (raffia, twine)
  5. (2) 6 foot wooden stakes (for longer fedge, one stake should be placed every 12 feet.)
  6. Garden gloves
  7. Lopping shears
  8. Metal fencing bar for making holes in the ground
  9. Sledge hammer
  10. 2mm steel wire to run the length of fence

Prior to planting:
We prepare willow cuttings fresh to order. This ensures that the stock arrives in prime condition. It is important that cuttings are planted as quickly as possible, and have soaked for a few hours prior, to replace lost moisture. If the cuttings are not able to be planted immediately, they must be stored in a cool, shady place. If weather is warm and drying, the cuttings must be kept moist by placing then in water for a few hours, and then placed in a fridge until being planted.

Fedge Planting Instructions

Step One: Laying Mat
Lay weed mat on desired site, and pin down the edges, as well as the mat every foot for neatness. Hammer the 6 foot wooden stakes into the ground at the end of the weed mat to help strengthen the structure. For longer structures, place the stakes every 12 feet. Secure steel wire to the wooden stake four feet from the ground, secure with a tack or a nail bent over. Run along all wooden stakes until you reach the end.

Step Two: Making Planting Holes
Your first two holes should be 1 foot from the end of the weed mat and half way along the width. They should be spaced 2 inches apart. Hammer the metal fence bar about a foot into the ground through the weed mat, wiggle to make sure that it will retract easily, then hammer another 4 inches into the ground. The wetter the ground area, the easier this will be. Use your tape measure to mark out where the rods should be placed, 2 inches apart along the length of the fedge.

Fedge Planting Instructions

Step Three: Placing the Willow
Placing the willow rods into the holes can be done as you go along, or at the end of the hole making process. The end willows, and every third willow rod should be of a thicker variety (strengthening end rods), with two thinner in between. Place both hands a foot apart on the rod near the base, pushing downward; force the rod into the hole.

Step Four: Weaving your Fedge
Start from one end and leave your two strengthening end rods upright. Cross over the following two rods and tie together at the crossing point a foot from the ground, then crossover the next two, tie at cross, and repeat for entire length. You should check that all of the crossover weaving is at a consistent height along the fedge.

Step Five: Weaving the Ends
A few rods will crossover beyond the end of the fedge rods. Bend these rods carefully 180 degrees around the ends of the stakes at a 45 degree angle upward and tie in the rod at the same height as the other rows. Do this with all the left over ends.

Willow Fedge